When your Kubota engine starts burning oil, making noise, or just doesn’t have the power it used to, it’s time for a rebuild. This oversized piston and ring set is exactly what you need when the cylinder walls have some wear but aren’t cracked or damaged. Instead of replacing the whole block, you can bore it .020″ over and get your engine running like new again.
What You’re Getting
- Complete piston and ring set sized .020″ larger than standard bore
- Quality aftermarket construction that meets OEM specifications
- Precision-fit rings that seal properly for good compression and oil control
- Everything you need for one cylinder in your rebuild project
Built for Real Farm Work
This set is designed for Kubota engines that need rebuilding but still have serviceable cylinder walls. When you’re facing an engine rebuild, boring the cylinders slightly oversized is often the most cost-effective way to get back to work. These parts handle the same loads and conditions as your original equipment.
Made to Last
TISCO has been making quality aftermarket parts for decades, and these pistons and rings are built to the same standards as the originals. The rings are properly heat-treated for long life, and the piston is cast to handle the heat and pressure of hard work.
Good to Know
You’ll need to have your cylinders professionally bored and honed to .020″ oversize before installation. Make sure to check your connecting rod and crankshaft condition while the engine is apart—it doesn’t make sense to put new pistons on worn bearings. Gap the rings according to your service manual for best results.
